STÖBICH® Omnicompact-FAA | Fire-resistant fire protection closure for separate conveyor technology.

SYSTEM: OMNICOMPACT-CSC

Product description

In the event of an alarm, self-closing, fire-resistant fire protection closure in the design of a lift-and-slide door with separate conveyor technology.

Type	Fire protection closure in the course of separate conveyor systems in the design of a lift-and-slide gate
Certification	General type approval Z-6.22-2664; in accordance with EN 16034:2014 in conjunction with EN 13241:2003+A2:2016
Closing direction	from top to bottom
Fire resistance	EI₂ 90 \| tested in accordance with EN 1634-1:2014-03 \| classified in accordance with EN 13501-2:2023
Closing cycles	C2 \| tested in accordance with EN 12605:2000-08 \| classified in accordance with EN 13501-2:2023
Environmental conditions	Not considered are special environmental conditions (e.g. humidity > 80%, ambient temperature < 5 °C and > 45 °C, wind loads, etc.)
Visible surfaces of the housing and guide rails	Galvanised \| RAL - smooth - silk gloss - standard colour shade \| NCS - standard colour shade

Downloads

SBS_Datenblatt_Omnicompact-FAA_EN_V01a_2025.pdf [ PDF ]

Legendary system components:
1 = Smoke detector
2 = Guide rails
3 = Mounting bracket
4 = Slat
5 = End element
6 = Drive motor
7 = Control with operating unit
8 = Manual release optional (manual release required if the control with operating unit is higher than 1.4 m above the upper edge of the finished floor)

Legal dimensioning:
Body
q = clear unfinished height
x = clear unfinished width
System
s = system height
y = clear system width
z = system width
Housing
t = depth
t₁ = Console
t₂ = Space requirement control box ceiling
h = Height
v = Offset between guide rail and winding housing
Guide rail
a = width
b = depth
Conveyor system
f = Separation point width (>107 mm)

Size dimensions and system structure

The dimensions of the brackets and guide rails may vary. The information provided in the quotation applies.

Fire resistance class	*Size max. [x x q] in mm**	Fabric/component	Wall thickness in mm**	Console	Guide rails
EI₂ 90	6000 x 5600	Lamella	≥ 240	A, B, C	Type 1
C2	6000 x 5600	Lamella

The installation situation must comply with the building code requirements of the country of installation. The fire resistance of a ceiling or wall support structure and the adjoining components must at least correspond to that of the fire and/or smoke protection closure/fire and/or smoke protection curtain. Proof of the stability and serviceability of the adjacent walls and components must be provided under general ambient conditions and in the event of fire. See also notes on the standard supporting structure in EN 1366-7:2004 or EN 1363-1:2020. The fire protection system must not be subjected to any additional load apart from its own weight, even in the event of fire.
* Deviations from size dimensions on request
** tested wall types according to the installation instructions